Clean Tips for Iron
Clean Tips for Iron
Recognize visible deposits on the soleplate? Then it is now: The best way to clean the iron immediately! Otherwise, leave these branded coverings - difficult, if not removable - traces on the clothes. Usually the contaminants consist of a conglomerate of burnt fibers, molten plastic (too hot ironed synthetic materials, for example), detergent residues, fat and calcium.
If you want to clean your iron, you have a choice of special detergents or try home remedies. The latter is worth a try in any case, if no suitable cleaner is available.
So you will not only long must penetrate through all conventional tips, we have financial advice iron clean compared and this also made a special cleaning pen over. For each experiment, we gave five minutes, because we assume that no one wants to scrub endless.
Clean advice Iron: Contents
- The tested cleaning agents for Iron
- Tip: descale steam iron
- Clean iron with salt: Test 1
- Test 2: Clean the iron with aluminum foil
- Clean iron with vinegar: Test 3
- Test 4: Clean the iron with baking powder or baking soda
- Test 5: Clean the iron with lemon juice or acid
- Clean iron with Ceranfeldreiniger: Test 6
- Clean iron with cleaning pen: Test 7
- Clean iron with home remedies: Conclusion
- Tips for a longer shelf life of your iron:
The tested cleaning agents for Iron
- aluminum foil
- Baking powder or baking soda
- Lemon juice or acid
- Iron Cleaner pen
If you want to clean a coated iron, you should rely on no account to funds that could damage the surface, such as pot cleaners, abrasives or salt - not even tentatively. Normally, the coating should largely prevent contamination. In any case, read in the instructions for how the iron must be cleaned.
We take an iron without steam function and a steam iron for testing - both older and with clearly recognizable, baked-on soils.
Suitable dose descaler for irons
Tip: descale steam iron
Who wants to clean a steam iron, which should advance or clean immediately afterwards and the water tank of the iron, d. H. descale. Also, you can buy special descaling agent or use lemon juice or, citric acid.
follow on special descaling agents, in the instructions of the manufacturer.
Fill if you want to take lemon juice or acid, moderately warm water with lemon juice without fruit ingredients (or dissolved in water teaspoon citric acid). not turn iron, as it could come at too high heat to undesirable crystallizations.
Then the iron over night in a shallow dish with the same solution (put iron, about 1 cm fill) so filled let stand. The next morning, nozzles and tank are free of lime and can be rinsed with clean, distilled water.
Clean iron with salt: Test 1
A thick layer of salt on a towel (not directly on the ironing board) pour, provide maximum heat iron on (without steam). ironing smoothly without pressure over the salt.
Result: is if any After five minutes, hardly anything away from the pollution. Probably the salt to the heated and slightly softer linings scrape, but hardly work without pressure. With pressure but it is feared that the salt could allow the soleplate (more) scratch so suffers the lubricity.
Caution, especially in coated iron: If you want to try to clean an iron with a sole made of Teflon, should in no case with salt.
Place a thick layer of salt on a towel.Without pressure several times over the salt "iron",Unfortunately without success. Salt is not suitable for iron cleaning.
Test 2: Clean the iron with aluminum foil
Place a large piece of aluminum foil with the matte side up on a towel. The iron to maximum temperature heating (without steam). ironing now for five minutes on the aluminum foil. The pads are to be deposited on the aluminum foil.
Result: Again, the period of five minutes is not really seen that the iron clean would even begin to have succeeded.
Aluminum foil with the matte side upAn improvement is made in the short time
Clean iron with vinegar: Test 3
The iron on slight temperature heat (without steam). rub for five minutes with a cloth soaked in vinegar kitchen towel or rag over the dirt. Caution: Do not clean with synthetic fiber cloth Iron - glued otherwise.
Result: The minimum lime deposits are gone, the dark coverings however. The smell is very unpleasant. Prolonged soaking on a cloth soaked in vinegar, but should work much better.
Please wear gloves, vinegar is aggressive and interacting in concentrated form or, for a long time, not good for nails and skin. Also avoid inhaling the fumes better.
Vinegar helps with calcium deposits.But dirt is not impressed.
Test 4: Clean the iron with baking powder or baking soda
From baking powder or baking soda to produce a paste with a little water. This applied to the sole of the cold iron. Then turn on the smallest stage and after three minutes rub the paste with a linen or cotton cloth. After that, the iron wipe until all residues are removed.
Result: A cleaning effect is barely visible, even this method is not suitable for steam irons, since the paste would penetrate into the openings. Perhaps a long action would achieve better cleaning (approximately overnight).
mix baking soda with waterApply paste to the soleplateMinimal cleaning action
Test 5: Clean the iron with lemon juice or acid
heating iron at a low level. A flap (or paper) moistened with lemon juice or dissolved citric acid and thus clean the bonded iron.
Result: This method to clean an iron smell something better than when trying with vinegar, but also in the short time not the hoped-for success leads. There is only a slight improvement can be seen.
Clean iron with cloth and lemonA small cleaning effectalso applicable to steam iron
Clean iron with Ceranfeldreiniger: Test 6
No special cleaners available for iron, maybe a Ceranfeldreiniger solves the problem? After all, it's also there to burnt residue. Iron so cold rub with Ceranfeldreiniger, leave for a few minutes - according to the manufacturer's instructions. Then rinse with clear water and a cloth and dry.
Result: The baked-on soils reduced recognizable. Clean but it is not. One would have probably repeat the process. also for a steam iron, it is probably not suitable as the cleaning paste sets in the holes.
let Ceranfeldreiniger act and polishbut not perfect a good result
Clean iron with cleaning pen: Test 7
Against the home remedies takes: a special cleaning pen to clean iron. The pin is used as described in the instructions. That is, in this case, the iron is placed on medium heat and abraded with the pen.
Carefully: The pen is this fluid and drip on the pad!
According somewhat inferior insensitive, so that the reference is not pulled from the board affected. Wipe with paper towels or a cloth made of cotton or linen. Then rinse with clear water and dry it.
Result: Simple and effective. Even with the very old iron, the dirt is burned long, it really must be completely replaced takes no longer than two minutes to all surfaces.
Use as directed by the manufacturerThe pads dissolve easily in both IronA clear winner
Clean iron with home remedies: Conclusion
The planned specifically for iron cleaning stick, it is easiest to clean an iron. After only a minute or two all coverings are removed. The scratches, resulting probably from a previous experiment with a glass scraper are, but this does not eliminate them.
Better than any home remedy - unfortunately
Who wonders, "How can I clean my iron - without chemicals" that goes best with the lemon juice method, but must be securely scrub much longer and / or soak.
No special cleaner for iron hand, an attempt to Ceranfeldreiniger is promising, but carefully pay attention in steam irons, not to bring the cleaner into the holes and, after this to clean the steam function.
Our little experiment, such as irons are best to clean, unfortunately, reveals that none of the home remedies in a reasonable time lead to an acceptable result. Softening the other hand is with lemon really easily and perfectly done. With the special descaler it is faster, but not better. In this case the home remedy is entirely equivalent, if you do not hurry. The cleaning effort is much the same in both.
Are clearly visible in both iron many scratches that would be even worse in a coated iron and must be removed by any cleaner and not by the special bracket cleaning pen.
Tips for a longer shelf life of your iron:
- avoid when ironing to drive the iron over zippers and buttons.
- Never go with abrasive cleaning agents or tools on the soleplate. Even the Schrubbseite a kitchen sponge can cause scratches.
- Always ensure the material signs of the garments and to the specified temperature setting. It is also not as likely to be melted synthetic fibers that leave residues on the soleplate.
- T-shirts and sweatshirts with flocked or printed motifs and inscriptions rather lay an old, slightly damp tea towel over it and then steam only with the iron. The smooth, without anything sticks to the soleplate and / or the label is damaged.
- Are sequins, tiny buttons, beads, embroidery or the like. When applied, first check that the garment ever washed and / or may also be ironed. Maybe it has to the cleaners. Also this work otherwise in any case with an old, damp tea towel between garment and the iron.
- Do not place the soleplate to unsuitable ground.
- Steam iron with distilled water use (there are free if you use a condenser). If it ever prove form scale deposits, descale the steam iron with Entkalker or lemon juice or acid.