Garden shelf build yourself

Garden shelf build yourself

Frequently used patio and garden tools such as garden shoes, rubber boots, dustpan and hand brush, watering and pruning shears, garden owners who like to reach. So that everything does not have to be constantly unearthed from the garden shed, or untidy lying around on the balcony, the purchase of a decorative garden shelf is recommended. With this construction manual the good piece is quickly assembled.

Garden shelf material

Batten, planed, 18 x 36 mm:
        Rear wall: 1.800 mm, 8
        Pages: 1500 mm, 10 pieces
        Transverse struts rear wall: 480 mm, 3 pieces
        Transverse struts Pages: 320 mm, 6 pieces
        Ground Contact: 338 mm piece 6
        Flooring: 480 mm, 30 pieces
        Diagonal brace rear wall: 1.600 mm, 1 piece
        Diagonal brace rear wall: 800 mm, 2 pieces
        Diagonal strut Page: 1,500 mm, 2 pieces
        Truss: 320 mm, 3 pieces
    Smooth-edged boards, Spruce, 95 x 18 mm:
        Roof: 500 mm, 4 (10)
        Roof: 482 mm, 4 pieces (11)
    Phillips screws, 4 x 30 mm, 210 pieces
    Screws and plugs for wall mounting, 2 pieces
    Genius PRO glaze, 750 ml, rosewood

Garden shelf tool

pencil
    ruler
    Protractor or set square
    Cordless Screwdriver
    spirit level
    impact drill
    Jig saw, rasp or
    abrasive paper
    Holzbohrer 5 and 6 mm
    Rock drill 8 mm
    brush glaze

Garden shelf assembly instructions

Garden shelf build yourself

You will be cut all bars in toom BauMarkt. Break first all edges with a rasp or sandpaper and paint all strips with glaze. (The headboards, you have to saw off will be repainted later.) Place the strips on the rear wall and the strips for the side panels next to each other, and draw the positions of the cross-connections.

Garden shelf build yourself

Now screw the crossbars on the bars of the back wall. Start with the outer strips, screw on it with a lateral distance of 18 mm. In between, you distribute the remaining strips with a uniform distance from each other and screw these firmly. Proceed to the side parts exactly here but exclude cross braces flush with the front bar from. The upper, middle and lower ridge projects, as shown on the drawing, at the trailing edge to 18 mm a. Now draw the gable on the back wall. The bevel begins at 1.500 mm and extends 45 ° upwards. Then the strips sawing with a jigsaw and pat the ends with the glaze after.

Garden shelf build yourself

After checking whether the strips with the lower edge of the respective parts are ° angle at 90, place the diagonal brace to the back wall,
drawing on the lengths and cut them off. Now simply screw. Then you draw the parts and follow the same process. The diagonal braces
the side parts must be above 20 mm shorter than the side, so that the roof fits later - these can also be mounted as described above.
Now screw the side panels to the back wall. Well just the baseboards to the already installed strips screw (if you down
begin, it can be later with the cordless screwdriver easier handling).

Garden shelf build yourself

Finally, you assemble together the roof, this screw the crossbars with a distance of 40 mm to the rear edge under the boards. The lower struts must have a distance to the lower edge of the roof of 140 mm. Now sit on the roof and screw it from the top with the sides and the back wall. Now attach the shelf to the back to the wall - and you can give it!

Garden shelf build yourself

Courtesy of Toom